Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.13 Connecting the receiver to a camera/recording device
1.
Slide the clip (1g) of the receiver (2) into the clip shoe (10a) of the hot
shoe adapter (10).
2.
Slide the camera shoe (10b) of the hot shoe adapter (10) into the hot
shoe of the camera.
3.
Tighten the central locking screw (2a) of the hot shoe adapter (10) until
the receiver is secure.
4.
Connect the 3.5 mm angled jack plug of the TRS cable (5) to the
corresponding socket (2a) on the receiver and the straight 3.5 mm
jack plug to the microphone input socket of the camera.
5.
Start recording by turning on the transmitter and receiver and waiting
for them to pair.
6.
Check the microphone system's functionality, and the device's quality
and settings.
7.
If the quality is poor, find a better position for the microphone or use
the wind shield.
6.14 Connecting headphones to the receiver
You can connect headphones to the receiver to listen to the sound directly.
1.
Connect the 3.5 mm jack plug of the headphones to the headphone
socket (2b) of the receiver (2).
2.
Check the function of the headphones and, if necessary, the volume.
6.15 Adjusting the volume
The volume is adjusted on the receiver. It is indicated on the transmitter by
the dynamic audio bar and on the receiver by the volume display and the
dynamic audio bar. The transmitter and receiver must be paired.
Channel A
Press the button
reached the desired volume.
→ The volume is switched between 0/3/6/9/12/15.
Channel B
Press the button
reached the desired volume.
→ The volume is switched between 0/3/6/9/12/15.
(2c) of the receiver (2) repeatedly until you have
(2e) of the receiver (2) repeatedly until you have
EN
29
Werbung
