Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
Press and hold the button
→ As soon as both units have paired, the icon
coloured level of channel A are displayed.
→ The transmitter is set to channel A by default.
4.
If the pairing did not work, repeat the procedure.
6.3 Pairing of the transmitter and the receiver
The transmitter and receiver are paired before leaving the factory.
When starting them up, they pair automatically in channel A.
If something goes wrong, they need to be paired again.
A
1.
Switch on both units.
2.
Press and hold the button
→ The icon
3.
Press and hold the button
→ The icon
→ As soon as both units have paired, the icon
coloured level of channel A are displayed.
6.4 Manual coupling of the transmitter and the receiver
Simultaneously press and hold the buttons
receiver (2) and the button
6.5 Muting the recording (Mute)
The recording starts the moment the transmitter and receiver are
switched on and paired. If you do not wish to record, you must mute
the transmitter.
1.
Switch on the transmitter and receiver and wait until they have paired.
2.
Briefly press the button
3.
Press the button
26
A
A
(not connected) is shown in the display.
(connects) is shown in the display of the transmitter.
(1c) once again to restart the recording.
(2e) on the receiver for 3 seconds.
A + 15 B + 15
(1c) on the transmitter for 3 seconds.
(2e) on the receiver for 3 seconds.
(1c) of the transmitter (1) for 3 seconds.
(1c) to pause / mute the recording.
(connected) and the
A + 15 B + 15
(connected) and the
(2c) and
(2e) of the
Werbung
