Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.6 Activate noise reduction (150 Hz)
1.
Briefly press the button
→ The noise reduction is activated.
2.
To stop, briefly press the key
6.7 Changing the channel
3.
To pair the transmitter and the receiver, press and hold the button
(1c) on the transmitter for 3 seconds. If this does not work,
press the button
4.
Press and hold the button
→ The channel changes from A > B.
5.
To switch back to channel A, once again press and hold the button
(1e) on the transmitter (1) for 3 seconds.
6.8 Connecting the lavalier microphone to the transmitter
1.
Connect the 3.5 mm jack plug of the lavalier microphone (6) to the
corresponding socket (1b) on the transmitter (1).
2.
Check the function and the quality of the microphone.
3.
If the quality is poor, find a better position for the microphone or use
the wind shield.
6.9 Putting on the wind shield
1.
Slide the wind shield (11) onto the microphone (1a), with the opening,
as far as you can.
2.
Check that the wind shield is correctly positioned, and that the
microphone is functioning properly.
6.10 Making use of the smartphone holder
1.
Fixate the smartphone holder (7) to a tripod or similar.
2.
Loosen the locking knob (7a) to be able to move the upper holder (7c).
3.
Slide the upper holder (7c) as far upwards as needed to let the
smartphone fit in.
4.
Slide the smartphone between the two holders (7d / 7c), position
it firmly and push the upper holder (7c) down until the smartphone
is fixated.
(1e) on the transmitter (1).
(1e) on the transmitter (1) once again.
(1c) on the transmitter for 3 seconds.
(1e) on the transmitter (1) for 3 seconds.
EN
27
Werbung
