OHAUS 3000-Serie Bedienungsanleitung Seite 177

3000 Series Indicators
4.6.3 Dynamic Weighing
Use this mode to weigh moving or oversized objects. The weight is held on the display until reset.
Manual method is available (refer to Section 3.6.3).
Begin Dynamic Weighing
Press the FUNCTION Mode button to start measurement.
NOTE: The example is for a setting of 5 seconds. During the averaging period, the countdown timer
decreases in one second increments.
NOTE: If SEt 0 was selected in the Dynamic menu item, the countdown timer is not displayed.
When the countdown has completed, the readings are averaged and held on the display.
The averaged weight is displayed until reset.
After removing the weight, reset the countdown timer by pressing the FUNCTION Mode button.
The scale is now ready to accept a new object.
4.6.4 Check Weighing
Use this mode to determine if the weight of a sample is within Pre-set limits.
Checkweighing Limits
When the FUNCTION Mode button is released, Clr.rEF is displayed.
Using or Recalling Stored Check Weighing Limits
Press the No button to recall the stored limits and proceed to checkweigh operation
Clearing Stored Check Weighing Limits
Press the Yes button to clear the stored limits.
NOTE: Press the FUNCTION Mode button successively to temporarily display the Under and Over
Limit values.
Editing the Under Setting
The display shows SEt.LO. Press the Yes button to edit setting..
Settings:
-99999 to 999999
Refer to Menu Navigation Section 3.2 to enter settings.
NOTE: The first digit will be used to show a negative value. Adjust the readability setting as needed
to allow an extra digit taken up by the negative sign
EN-31
to