ABB WaterMaster FET100 Bedienungsanleitung Seite 38

WaterMaster FET100
Elektromagnetischer Durchflussmesser / Messumformer
Certificate No.:
Date of Issue:
Manufacturer:
Manufacturing location(s):
ABB Engineering
(Shanghai) Limited
No.5, 369 Nong,
Chuangye Road,
Pudong District,
Shanghai
China
This certificate is issued as verification that a sample(s), representative of production, w as assessed and tested and
found to comply w ith the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products
covered by this certificate, w as assessed and found to comply w ith the IECEx Quality system requirements. This
certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as
amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified
documents, w as found to comply w ith the follow ing standards:
IEC 60079-0 : 2007-10
Edition: 5
IEC 60079-15 : 2010
Edition: 4
IEC 60079-31 : 2008
Edition: 1
This Certificate does not indicate compliance with electrical safety and performance requirements other than those
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
GB/FME/ExTR11.0005/00
Quality Assessment Report:
GB/BAS/QAR08.0001/02
Abb. A.10 IEC-Typenprüfungszertifikat Nr.: IECEx FME10.0006X (Seite 2 von 3)
36
IECEx Certificate
of Conformity
IECEx FME 10.0006X
2012-09-17
ABB Limited
Oldends Lane,
Stonehouse,
Gloucestershire
GL5 5DZ
United Kingdom
Explosive atmospheres - Part 0:Equipment - General requirements
Explosive atmospheres - Part 15: Equipment protection by type of protection "n"
Explosive atmospheres – Part 31: Equipment dust ignition protection by enclosure 't'
expressly included in the Standards listed above.
GB/FME/QAR10.0007/01
Issue No.: 0
Page 2 of 3
OI/FET100/ATEX–DE Rev. A