cecotec BOLERO DRESSCODE 10800 INVERTER A Bedienungsanleitung Seite 120

ENGLISH
10. Cancellation of a running programme (if necessary)
Turn the wash cycle selector to turn off the machine while the light under the
-
is on.
If the water level and/or temperature is low enough, the door will unlock and can be
-
opened.
The door will remain locked if there is a higher water level in the drum. To unlock the door,
-
first turn the wash cycle selector to select the SPIN programme, then turn off the SPIN
option by pressing the SPEED button to set the spin speed to "-" (should be displayed on
the digital display).
Press the START/PAUSE button
-
drum during the wash cycle. The door unlocks at the end of the programme.
11. Switching off the device after the end of a washing programme
At the end of the cycle, the message END is shown on the digital display.
-
The door can only be opened when the DOOR LOCK
-
Check that the DOOR LOCK indicator light is off, then open the door and remove the
-
laundry.
- Turn the wash cycle selector to switch off the machine to the OFF position.
Leave the door ajar to allow the inside of the drum to dry out and prevent odours and
-
mould growth.
5. CLEANING AND MAINTENANCE
Warning
Before cleaning or maintaining, unplug the appliance and close the tap.
Proper maintenance on the washing machine can extend its working life. The surface can
-
be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any
water overflow, use a cloth to wipe it off immediately.
Do not use abrasive cleaners or scouring pads to clean the device.
-
Do not use pressurised water to clean the equipment.
-
Cleaning the drum
The rusts left inside the drum by the metal articles shall be removed immediately with
-
chlorine-free detergents.
Do not use steel wool.
-
Note
Do not put laundry in the washing machine during the drum cleaning.
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
120
to run the SPIN programme. Water will drain from the
indicator light goes out.
symbol