Husqvarna Z454X Bedienungsanweisung Seite 26

Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
• Clean the area before you lubricate a part on the
product.
• Use oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
Refer to Lubrication
Lubricate the grease nipple on the pivot axle
A
with a grease gun.
Lubricate the grease nipple on the wheel axle
B
with a grease gun.
C Lubricate the grease nipple with a grease gun.
Replace the engine oil.
D
Replace the oil filter.
Do a check of the hydraulic oil level.
E Replace the hydraulic oil.
Replace the hydraulic oil filter.
Always use good quality grease. Always use
recommended oil, refer to
To lubricate the front wheels
Note:
Use a grease gun when you lubricate the front
wheels.
• Lubricate each set of front wheel mounts (A) and
bearings (B) 3-4 strokes. (Fig. 62)
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
10
For Parker HT-1000, replace each 750 h. For other qualified hydraulic oils, first change 750 h, then each 500
h. For other hydraulic oils not listed, first change 750 h, then each 250 h.
11
For Parker HT-1000, replace each 750 h. For other qualified hydraulic oils, first change 750 h, then each 500
h. For other hydraulic oils not listed, first change 750 h, then each 250 h.
26
10
11
Technical data on page 30 .
Troubleshooting
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION:
petroleum products to clean drive belts.
Lubrication schedule
(Fig. 2)
Interval
Month Each
Yearly
ly 25 h
X
X
X
X
X
To lubricate the cutting deck spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes. (Fig.
63)
Note:
Use a grease gun with a rubber hose when
you lubricate the cutting deck spindles.
Do not use gasoline or other
Each Each Each
50 h 100 h 500 h
X
X
X
X
1741 - 002 - 22.08.2023