Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Once again, keep pressing the "Up" key or the "Down" key until the required digit is displayed in the
second position of the PIN.
Move to the third and fourth positions of the PIN and set them in the same way.
Note:
"1221" is the preset PIN for accessing the configuration menu. This PIN can be modified
via the PDU website.
Make a note of the new PIN number and keep it somewhere safe.
Finally, press the "Return" key (fig. 15, item 8). The DHCP menu will appear. The "
the current DHCP setting.
Use the "Down" key to select the DHCP setting "OFF" and press the "Return" key to confirm your
selection. The first page of the IP v4 Setup menu for setting the IP address will appear.
In the same way as you entered the PIN, enter an IPv4 address permitted in the network and confirm
with "Return".
Press the "Down" key to move to the page 2 of the IP v4 Setup menu.
If necessary, amend the subnet mask to the required setting and confirm with "Return".
Press the "Down" key to move to the page 3 of the IP v4 Setup menu.
If necessary, amend the gateway to the required setting and confirm with "Return" to save the altered
network settings. The new network settings will be displayed.
Connect the PDU to your Ethernet LAN with a network cable (fig. 15, item 5).
6.2
Settings via the PDU website
Using a network cable, connect the device to your computer via the Ethernet interface (fig. 15,
item 5).
Note:
You may need to use a cross-over cable for this purpose.
Change your computer's IP address to any address within the range 192.168.0.xxx, e.g.
192.168.0.191. The default address 192.168.0.200 of the device must not be used.
Set the subnet mask to the value 255.255.255.0.
If applicable, switch off the proxy server in the browser to facilitate a direct connection to the device.
In the browser, enter the address http://192.168.0.200 (fig. 17, item 1). The login dialog for logging
in to the device will be displayed.
Log in with the username admin and the password admin (fig. 17, item 2).
In the left-hand section of the overview window (navigation area), click the Processing Unit entry
(fig. 17, item 3), and in the right-hand section (configuration area), click the Configuration tab
(fig. 17, item 4).
In the Network group box, click on the TCP/IP button (fig. 17, item 5).
Note:
The following sections describe in detail how to make the setting for the IPv4 protocol.
Further notes regarding the TCP/IP configuration can be found in section 1.1.
In the TCP/IP Configuration window, change the device's IP address in the IPv4 Configuration
group box to an address permitted in the network (fig. 17, item 6).
If necessary, correct the settings for the subnet mask and the gateway.
Rittal PDU international/PDU UK power distribution unit
Settings of the PDU metered/switched/managed
" symbol marks
29
EN
Werbung
