Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 9 control channels. It can
also be switched to a mode with 3, 4, 5 or 6 channels if different functions are required. To be able to
operate the device with a DMX controller, the DMX starting address must be set. The starting address
depends upon which DMX controller is being used. Please refer to the controller's documentation.
1
Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2
The display indicates 3 CH (3 DMX channels), 4 CH (4 DMX channels), 5 CH (5 DMX channels) 6 CH (6
DMX channels) or 9 CH (9 DMX channels). Use the buttons UP and DOWN to select the desired number
of DMX channels. Confirm with the ENTER button.
3
Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4
The dot will flash when DMX signals are being received. If no DMX signals are available, the display and
the dot flash alternately.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
3 channel mode
Channel
1
2
3
4 channel mode
Channel
1
2
3
4
5 channel mode
Channel
1
Master dimmer
2
Strobe effect
3
Preset colors
Value
Function
000 – 255
Red 0-100%
000 – 255
Green 0-100%
000 – 255
Blue 0-100%
Value
Function
Red 0-100%
000 – 255
Green 0-100%
000 – 255
Blue 0-100%
000 – 255
White 0-100%
000 – 255
Value
Function
000 – 255
Total brightness 0-100 %
No function
000 – 009
Strobe with increasing speed
010 – 255
000 – 009
No function
010 – 019
Red
020 – 029
Green
030 – 039
Blue
040 – 049
White
050 – 059
Yellow
060 – 069
Magenta
070 – 079
Cyan
26/32
00123059, Version 1.0
Werbung
