Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1
Press the MENU button so many times until Soun is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program (So1–So9). Confirm with the
ENTER button.
2
Press the MENU button so many times until SEnS is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to Adjust the microphone sensitivity to the volume of the music
(SE 1 = low, SE 9 = high).
3
Press the MENU button so many times until SPEE is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from SP 1 (slow) to
SP 9 (fast). Confirm with the ENTER button.
4
If you enable the silent scene mode (on setting) in menu item SILE, the LEDs will be switched off if the
volume is too low or if there is no sufficient bass beat. If you disable this mode (off setting) the LEDs
remain on during periods without music.
Color mix
In Colo mode each of the 4 colors can be individually adjusted in intensity. The device will then constantly
emit the chosen color setting.
1
Press the MENU so many times until Colo is indicated in the display. Confirm with the ENTER button.
2
Now the display indicates the letter R for the color and the corresponding brightness value. Use the
buttons UP and DOWN to adjust the desired brightness.
3
Confirm with the ENTER button. Now the color green can be set; then blue and white until the desired
color intensity is achieved.
Total brightness
Menu diMM allows adjusting the total brightness for all stand-alone operating modes: Stat, Auto, Soun and
Colo.
1
Press the MENU button so many times until diMM is indicated in the display. Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to adjust the desired brightness (dI 1 = dark, dI 9 = bright). Confirm with
the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated in the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
24/32
00123059, Version 1.0
Werbung
