T+A SACD 1245 R Betriebsanleitung Seite 35

   
 
 
Adjustment of the display brightness
By repeatedly pressing the 
of the alpha-numerical display can be adjusted in 3 steps:
1. Normal setting:
good legibility, even in bright conditions and sunlight.
2. Subdued:
Subdued setting, for dark locations.
3. Display off:
the screen is switched off completely. The screen
lights up for a few seconds whenever a command is
sent to the unit, so that you can see the new setting.
Note:
If you set brightness level 3, the screen switches briefly
to normal brightness every time you give a command, so
that you can check the settings easily. After about four
seconds the screen automatically switches back to your
preferred brightness level. If you change the brightness
level, this also means that the new value only becomes
effective after about four seconds.
 
 
 
 
Not used.
 
 
   
This button selects special programming functions for
creating, editing and
(playlists).
 
 
Cursor Block
 
 
        
 
 
These multi-function buttons are used for navigation
within On-Screen-Menus and for play back control (track
jump, cueing etc.).
Play Back Control
   
These buttons are used to jump to the next /
 
 
previous track, chapter or title.
Fast Forward / Reverse
   
The fast mode is ended by pressing the 
 
 
button.
A short keypress will start the playback or will
   
resume playback after a pause.
 -button the brightness  
deleting MEMO–programs
(multi function buttons)
  
  
   
   
A short press on this button switches the unit to Pause.
Press the   -button to resume playback.
 
   
   
The    button ends playback. 
   
 
 
A short press on this button starts playback, or resumes
playback after a Pause.
 
 
Screen window
All the screen elements of the SACD 1245 R are
displayed in a clearly laid-out window on the integral
screen:
1 / 2 / 3 This display area shows the currently active
oversampling algorithm (1 . . . 3). If none of
the numbers are lit, the standard algorithm
(FIR Filter) is active.
CD is lit if a standard audio CD or the CD layer
of hybrid SACDs is played.
is lit when a SACD is played.
SACD
is lit when playing a multi-channel SACD.
MCH

This indicator is lit, if the analogue output of
the SACD 1245 R is switched to high
bandwidth (WIDE-mode).

The symbol glows when the output signal is
inverted.
123,45 Alpha-numerical display area for indication
of track, time or operation mode.
This area is also used for context depending
messages for example during 'SETUP
menus'.
Note:
In case the message '
display, the SACD 1245 R has become too hot. Please
make sure that the device is sufficiently supplied with
cooling air and that the air can freely flow around the
case of the device. Read and follow all instructions given
in chapter Setting up the SACD 1245 R. Please do not
place the SACD 1245 R directly on top of other hot
devices like amplifiers etc.
35
OVERHEAt OVERHEAt ' is displayed on the
OVERHEAt OVERHEAt