Kenwood KWL90.004SI Bedienungsanleitungen Seite 9

To Use Your Kitchen Machine
- Manual Mode
Refer to Illustrations
Make sure the warming plate area,
temperature sensor and external
surface of the bowl base are clean.
Failure to do this will affect the
temperature sensor, resulting in poor
warming performance.
1 Plug in and press the On/Off switch.
2 Push the head-lift lever down and
raise the mixer head until it locks.
3 Fit the bowl, turn clockwise to lock.
4 Place the required tool into the
socket. Then push up and turn the
tool to lock into position.
5 Lower the mixer head by pushing the
head release lever down and lower
the mixer head until it locks.
6 Set the required time, speed and
warming level.
Turn the control dial clockwise to
use continuous speeds, turn anti-
clockwise to use stir intervals and
pulse (P).
Press and hold the control dial to
activate the pulse.
7 Press the control dial to start.
8 To stop/pause the unit at any time
press the control dial.
9 Release the tool by turning clockwise
to unlock from the tool socket and
then remove.
Important
Ensure that no bowl tools are fitted or
stored in the bowl when using other
outlets.
Using Preset Programmes
Refer to Illustrations
1 Swipe right to access the preset
menu.
2 Choose the preset you wish to use.
3 Follow the instructions on the
display screen.
4 Press the control dial to start.
A I
–
J L
–
5 To stop the unit at any time, press
the control dial. Take care as the
bowl may be hot.
After Warming
Be careful when handling
or touching any part of the
appliance when being used in
warming mode or after warming,
IN PARTICULAR THE BOWL,
WARMING PLATE AND TOOLS
as they will remain HOT long
after the appliance has been
switched off.
Use the two side handles to
remove and carry the bowl. Use
oven gloves when handling the
hot bowl and hot tools.
Manual Operation
(Attachments)
1 Remove High speed outlet/Slow
Speed outlet cover (if applicable).
2 Fit attachment according to
specific instructions supplied.
3 Set the required time and speed
(refer to illustrations
H - I). Press the control dial to
start.
To stop the unit at any time, press the
control dial again.
To Remove And Fit Outlet
Covers
High-Speed Outlet Cover
1 To remove the cover, use the grip
on the side and lift upwards.
2 To fit, place the cover over the
outlet and drop into place.
Slow-speed Outlet Cover
1 To remove the cover, use the grip
on the top and pull outwards.
2 To fit, place the cover over the
outlet and push into place.
5