Kenwood KWL90.004SI Bedienungsanleitungen Seite 19

Troubleshooting Guide
Problem
The whisk, K-beater or
ceaming beater knocks
against the bottom
of the bowl or not
reaching the ingredients
in the bottom of the
bowl.
Slow speed attachment
cannot be fitted.
The Stand Mixer stops
during operation.
Display shows error
message E27.
Display screen shows
an alpha/numerical
error code different
from E:27.
Cause
Tool at the wrong height
and needs adjusting.
Check your attachment is
compatible for use with
your model.
Twist connection system
required (Model KAX)
Overload protection or
overheat system activated.
Maximum capacity
exceeded.
Appliance not functioning
properly.
15
Solution
Adjust the height using a
suitable spanner – see "Tool
Adjustment" section.
Attachment must have the KAX
twist connection system
fit the outlet.
If you own attachments
featuring the Bar Connection
System you will need to
use the KAT002ME adaptor
to connect these to the Twist
Connection System on your
Stand Mixer.
For more information visit
www.kenwoodworld.com/twist.
Unplug and check for
obstruction or overloading.
If the machine will not operate,
remove some of the ingredients
to reduce the load and restart.
If this still does not resolve the
problem, unplug and allow to
stand for 45 minutes. Plug in
and restart.
If the machine does not restart
following the above procedure
contact " Customer Care" for
further advice.
Switch off the appliance, wait
30 seconds, then switch back
on.
If the problem persists, contact
an authorised Kenwood
Service Centre. To find up to
date details of your nearest
Kenwood Service Centre visit
www.kenwoodworld.com or
the website specific to your
country.
to