Connection With The Mains; Operation; Stand-Alone Mode; Control Board - EuroLite LED PST-15W MK2 COB Bedienungsanleitung

Set the Slave-mode on every slave-device.
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please see further instructions under Operation.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the device to the mains, the LED PST-15W MK2 COB RGBW Floor Spot/Wash starts
running.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and via
the EUROLITE IR-8 remote control or in DMX-controlled mode via any commercial DMX controller.

Stand-alone mode

In the stand-alone mode, you can do without a controller.
Disconnect the EUROLITE LED PST-15W MK2 COB RGBW Floor Spot/Wash from the controller. Please
refer to the instructions under chapter Control Board.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
programs or select a DMX channel mode.
MODE ENTER UP DOWN
International
L
N
Enter the menu by pressing the MODE-button. Browse through the menu by
pressing UP or DOWN. Press ENTER in order to select the desired menu. You
can change the selection by pressing UP or DOWN. Press ENTER in order to
confirm. You can leave every mode by pressing MODE. The functions provided
are described in the following sections.
24/30 00099143, Version 1.1