Herunterladen Inhalt Inhalt Diese Seite drucken

Dmx512 Control; Connection Between Devices; Master/Slave-Operation - EuroLite LED PST-15W MK2 COB Bedienungsanleitung

Floor dmx spot/wash
Vorschau ausblenden Andere Handbücher für LED PST-15W MK2 COB:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

DMX512 control

The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX cable and 3-pin XLR plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
120
Caution: At the last fixture, the DMX cable has to be terminated. Plug the terminator with a
 resistor
between Signal (–) and Signal (+) in the DMX output of the last fixture.

Connection between devices

On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention: It is recommended to renew the connection with the power mains after every 8 devices.

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear of the LED PST-15W MK2 COB RGBW Floor Spot/Wash you can find an XLR-jack (DMX Out)
and an XLR-plug (DMX In), which can be used for connecting several devices.
Choose the device which is to control the spotlights. Set the desired Master-mode on the master-device.
This device then works as master-device and controls all other slave-devices, which are to be connected to
the master-device via a balanced microphone lead. Connect the DMX out connectors with the DMX input
plug of the next device.
23/30
00099143, Version 1.1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis