uebler X21S Montage- Und Bedienungsanleitung Seite 18

24 23 2 37
36
22
I
21
II
38
Attention
Only attach the bracket (2) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
7. Place the bicycle on the wheel rails and position the clamp (23)
of the holder (2). Secure the bicycle against tipping.
8. Screw the clamp (23) to the bicycle frame with the twist
grip (24).
9. Lock the holder (2) with the key (36) and remove the key (36).
10. Pass the lashing strap (21) centrally between two spokes,
thread it into the buckle (38) and tighten it.
Attention
Do not tighten the lashing straps (21) too firmly, otherwise the
tyres or rims could be damaged.
11. Use the tensioners (22) to tighten the lashing straps (21)
(arrow I).
Note
The screw threads in the holders must be regularly cleaned and
greased to prevent the twist grips from seizing up.
Mounting the second bicycle
2
The second bicycle is mounted in the same manner as the first.
Note that the bicycles are mounted in opposite directions.
Attention
Only attach the bracket (3) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
The second bicycle is attached using the long bracket (3).
M+P-25A-0279
Mounting the third bicycle
The third bicycle is mounted in the same manner as the first.
Note the opposite arrangement of all bicycles.
Attention
Only attach the bracket (4) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
The third bicycle is attached to the second bicycle with an
additional bracket (4).
4. Uebler X31S hitch rack for 3 bicycles (Order no. 15770)
- 16 -
3
4
4
M+P-25A-0160
M+P-25A-0161