AEG MW 5 Originalbetriebsanleitung Seite 23

4. Connect the charging coupler (9) to the charging
socket on the vehicle.
The charging process will start automatically.
The „Charge" LED (5) will flash.
The vehicle will lock the charging coupler and
prompts charging. The charging coupler will remain
locked during charging. The charging coupler can
only be disconnected once charging has completed
or has been cancelled.
Cancelling the charging process
The charging process can be cancelled if you wish
to use your vehicle before it is fully charged.
DaNGER!
Risk of electric shock and fire!
Always stop the charging process before discon-
necting the charging coupler from the vehicle.
aTTENTION!
Risk of damage!
Never unplug the charging coupler from the vehicle
when the charging coupler is locked.
The process should always be cancelled using the
vehicle's controls. If unable to do so for safety rea-
sons (e.g. vehicle on fire), switch off the building's
circuit breaker.
Stopping the charging process
When the vehicle is fully charged, the vehicle will
stop the charging process and unlock the charging
coupler.
The „Charge" LED (5) will stay on.
aTTENTION!
Always first disconnect the charging coupler from
the vehicle. Then unplug the mains plug from the
230 V mains socket.
1. Disconnect the charging coupler (9) from the
vehicle's charging socket.
2. Attach the protective cover (10) to the charging
coupler (9).
3. Close the cover to the vehicle's charging socket.
4. Unplug the mains plug (1) from the 230 V mains
socket.
English 23