Herunterladen Diese Seite drucken

EuroLite LED WF-30 Wassereffekt Bedienungsanleitung Seite 24

Led-projektionseffekt für wasserspiegelungen, rgb-farbmischungen & dmx

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the
remote control press the small bar with the groove to the right and at the same time remove the battery
support. For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 9 control channels.
However, it can also be switched to a mode with 6 channels if different functions are required. To be able to
operate the device with a DMX controller, the DMX starting address must be set for the first DMX channel.
The starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
1
Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2
The display indicates 9 CH (9 DMX channels) or 6 CH (6 DMX channels). Use the buttons UP and
DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
3
Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4
A dot will light up when DMX signals are being received. If no control signals are available, the display
will be flashing.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
6-channel mode
Channel
1
000 – 255 Total brightness 0-100%
Master Dimmer
2
000 – 009 No function
Strobe Effect
010 – 255 Strobe with increasing speed 0-100%
000 – 009 No function
010 – 019 Red
020 – 029 Green
030 – 039 Blue
040 – 049 Yellow
050 – 059 Magenta
060 – 069 Cyan
070 – 079 Dark orange
080 – 089 Green yellow
3
Preset colors
090 – 099 Salmon
100 – 109 Turquoise
110 – 119 Light green
120 – 129 Orange
130 – 139 Straw
140 – 149 Lavender
150 – 159 Light blue
160 – 169 Dark blue
170 – 179 Pink
Value
Function
24/28
00123661, Version 1.0

Werbung

loading

Diese Anleitung auch für:

51918545