EuroLite LED WF-30 Wassereffekt Bedienungsanleitung Seite 23

Fade
Menu point Fade allows the adjustment of the fade function in the stand-alone operating modes Auto and
Soun.
1 Press the MENU button so many times until Fade is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to choose on (fade function on) or oFF (fade function off). Confirm with
the ENTER button.
Direction adjustment
Menu dlrE allows the adjustment for change the motor rotation.
1 Press the MENU button so many times until dlrE is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to set the following settings. PRO for random motor rotation, CLo for
clockwise motor rotation or Ant for counterclockwise motor rotation. Confirm with the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated in the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
Remote control IR-7
The device must be activated for remote control. For this, set menu item InFr to on. When actuating a
button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
Button Function
BLACKOUT LEDs off
AUTO Automatic mode; program selection with (+)/(‒)
SOUND Sound control; program selection with (+)/(‒)
Strobe effect for automatic mode and sound control;
STROBE flash rate setting with (+)/(‒).Press the strobe button
again to exit the program.
SPEED Running speed in
SENSITIVITY Microphone sensitivity; setting with (+)/(‒)
DMX DMX mode
MANUAL
Color mode; select colors with R/G/B (+)/(‒)
FADE Color fade mode
1-9 Total brightness; 1 = dark, 9 = bright
23/28
automatic mode; setting with (+)/(‒)
00123661, Version 1.0