CASO DESIGN VC 330 Original Bedienungsanleitung Seite 47

► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.
► Carefully return all removable parts to their original positions to avoid air leakage or
faulty operation.
19 Troubleshooting
The following table may help you narrow down and address minor malfunctions:
19.1 Safety notices
WARNING
► Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
19.2 Troubleshooting table
Fault
Device does not turn
on
A complete vacuum is
not being created in
the bag.
The bag is not being
sealed correctly
The bag does not hold
the vacuum after it has
been sealed
PLEASE NOTE
Possible Cause
Defective power cord
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is residue on the
welding and the seal
The sealing bar is
overheating so that the bag
melts
Roll / bag is not positioned
correctly.
The bag is defective
To Rectify
Send device to Customer Service
Position the bag correctly
Select another bag
Clean the welding / seals and
retry once they are dry
Open the cover on the unit and
let it cool down for a few minutes.
Please use only specified bags
and rolls
Carefully follow all the steps in
Chapter Vacuuming and sealing.
Select another bag; wrap paper
around any sharp edges within
the bag.
47