EINHELL TPR 180 Bedienungsanleitung Seite 9

Anl. TPR 180 31.03.2004 13:48 Uhr
Replace immediately.
Never use segmented cutting wheels.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
Never leave the machine unattended in rooms
with children.
Always pull out the power plug before examining
the electric motor compartment system.
5. Technical data
Motor rating
Motor speed
A.c. motor
Insulation material class
Insulation
Cut length
Jolly length
Cut height 90°
Cut height 45°
Cutting table:
Dimensions
Diamond cutting wheel
Noise emission levels
The noise emitted by this saw is measured in
accordance with EN ISO 3744; EN ISO 11201
The noise at the workplace may exceed 85 db
(A). The user will require noise protection
measures if this is the case. (Wear ear-muffs!)
With-load
operation
Sound pressure level 71.2 dB(A)
Sound power level 84.2 dB(A)
6. Before using for the first time
The machine must be set up so that it stands
firmly, i.e. it must be securely screwed to a work
bench, the base frame supplied in delivery, or
similar.
All covers and safety devices must be correctly
attached before the machine is used for the first
time.
Seite 9
The cutting wheel must rotate smoothly.
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
7. Assembly and operation
7.1 Assembly of the base frame and cooling
water pump (Fig. 2-4)
Place the cooling water pump (13) in the trough
(3).
Fill with water until the pump (13) is full.
Place the complete tile cutting machine in the
trough (3) (see Fig. 2).
Unscrew the star grip screw (11) (for securing
during transportation!).
600 W
7.2 ON/OFF switch (Fig. 5)
2950 rpm
To switch on, press the "1" on the ON/OFF
230 V ~ 50 Hz
switch (16).
Class B
Before you begin cutting, wait until the cutting
IP54
wheel has reached maximum speed and the
cooling water pump (13) has started supplying
430 mm
the cutting wheel with water.
430 mm
To switch off, press the "0" on the switch (16).
max. 25 mm
max. 15 mm
7.3 90° Cutting (Fig. 4/6)
Loosen the star grip screw (12).
500 x 385 mm
Set the angle stop (5) to 90° and retighten the
ø 180 x ø 25.4
star grip screw (12).
Retighten the screws (28) to fasten the angle
stop (5).
Move the machine head (29) to the far end with
the handle (9).
Position the tile against the rail fence (6) on the
angle stop (5).
Switch on the tile cutting machine.
Caution: Always wait until the cooling water has
reached the cutting wheel (2) first.
No-Load
Move the machine head (29) slowly and
operation
smoothly forward through the tile with the handle
60.6 dB(A)
(9).
73.6 dB(A)
Switch off the tile cutting machine after
completion of cutting.
7.4 45° Diagonal cut (Fig. 7)
Set the angle stop (5) to 45°.
Cut as described in 7.3.
GB
9