Additional Safety Instructions; Technical Data; Before Using For The First Time - EINHELL NEW GENERATION STR 300 L Bedienungsanleitung

Anleitung STR 300 L_SPK1
GB
correct operation and safety regulations (see
supplementary sheet) before using for the first time.

4.2. Additional safety instructions

Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
Wear safety goggles.
Wear ear-muffs.
Wear safety gloves.
Never use cracked diamond cutting wheels.
Replace immediately.
Never use segmented cutting wheels.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
Never leave the machine unattended in rooms
with children.
Always pull out the power plug before examining
the electric motor compartment system
.

5. Technical data

Motor rating
Motor speed
AC motor
Insulation material class
Protection type
Table size
Cut length
Jolly length
Max. workpiece thickness 90°
Max. workpiece thickness 45°
Diamond wheel
Weight
Laser class
Laser wavelength
Laser output
Laser power supply
Load factor:
A load factor of S2 20 min (intermittent periodic
duty) means that you may operate the motor
12
07.09.2006 13:38 Uhr Seite 12
continuously at its nominal power level (1500 W)
for no longer than the time stipulated on the
specifications label (20 minutes ON period).
If you fail to observe this time limit the motor will
overheat. During the OFF period the motor will
cool again to its starting temperature.
Noise emission levels
The noise emitted by this saw is measured in
accordance with EN ISO 3744; EN ISO 11201
The noise at the workplace may exceed 85 db
(A). The user will require noise protection
measures if this is the case. (Wear ear-muffs!)
Sound pressure level
Sound power level

6. Before using for the first time

The machine must be set up so that it stands
firmly, i.e. it must be securely screwed to a work
bench, the base frame supplied in delivery, or
similar.
All covers and safety devices must be correctly
attached before the machine is used for the first
time.
The cutting wheel must rotate smoothly.
Check that the voltage on the rating plate is the
2200 W S2 20 min same as your supply voltage before you connect
the machine to the power supply.
3000 rpm
230 V ~ 50 Hz
Class B 7. RCD plug (Fig. 16)
IP54
Connect the RCD plug (41) to the power supply.
920 x 550 mm
Press the reset button (42) and the control lamp (43)
920 mm
will begin to shine. Press the test button (44) to
920 mm
check the function of the RCD plug. If everything is
70 mm working properly the control lamp (43) will go out and
the contact to the power supply will be interrupted.
55 mm
The RCD plug triggers at a fault current of 30 mA.
Ø 300 x Ø 25.4
Defective RCD plugs must be replaced by a qualified
75 kg
electrician.
2
Press the reset key (42) again in order to be able to
start up the machine.
650 nm
< 1 mW
2 x 1.5 V (AAA)
No-Load operation
94,5 dB(A)
107,5 dB(A)