voestalpine bohler welding URANOS 2700 PMC Betriebsanleitung Seite 48

E19 System configuration alarm
E20 Memory fault alarm
E21 Data loss alarm
E40 System power supply alarm
E43 Coolant shortage alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
E56 Voltage level exceeded (Alarm)
E64 Voltage level exceeded (Warning)
E57 Voltage level exceeded (Alarm)
E65 Voltage level exceeded (Warning)
E74 Motor 1 current level exceeded (Warning)
48
3.14 Rear panel
1 Power supply cable
Connects the system to the mains.
2 Gas fitting (MIG/MAG)
3 Signal cable (CAN-BUS) input (RC)
4 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.
3.15 Sockets panel
1 Torch fitting
Permits connection of the MIG/MAG torch.
2 Negative power socket
For connection of earth cable in electrode welding.
Allows the connection of the earth cable in MIG/MAG
and Pulsed MIG/MAG.
For connection of TIG torch.