AMS VICAM--RADAR Bedienungsanleitung Seite 2

WARNING
Storage:
- Do not expose the device to excessive heat or cold. This device must be stored at a temperature of between -30°C and +80°C, and its operating
temperature range is between -20°C and +70°C. Its maximum humidity is RH90%.
- Never use this device in environments with excessive humidity, dust or smoke.
- Avoid dropping or knocking the device.
- Never pierce, scratch or use abrasive cleaning products on this device.
- Never place cables where they can be crushed or stepped on.
Operating precautions
- The device can be powered using a 12V or 24V car battery or a vehicle electrical system.
- Incorrectly connecting the electrical system or power supply will damage the sensor and the control unit.
- The system tests and inspections described in these instructions and a report of the results must be included in the daily maintenance report.
Units on vehicles in operation must be tested every day before the vehicle begins operation. The results of this test must be recorded in the
maintenance log.
- The radar detection system is designed to be used on light commercial vehicles and mechanical equipment. Proper installation requires good
understanding of the vehicle/machine's electrical systems and procedures, as well as complete understanding of the installation process.
Warning:
- Do not open the unit. This may result in damage, short circuits or electric shocks that may cause serious injury or death.
- The equipment is not an alternative to safe driving practices.
- The wire left loose on cable E must be insulated to avoid short circuits.
2
AMS Diffusion - Rue des Galeries - ZA du Chevalement - 59286 Roost Warendin - FRANCE - Tél. +33 (0)3.27.94.44.44 - Fax. +33 (0)3 27 94 44 45
Email : contact@ams-diffusion.fr - www.ams-diffusion.com RCS DOUAI A 451 360 382 - CODE APE 4531Z - SIRET 451 360 382 00035 - TVA FR 55 451 360 382
1. COMPONENTS
Control unit
Sensor
Monitor
connector cable
(3m)
USB cable
Buzzer
Sensor connector
cable (3m)
Extension cable
(1.5m)
Silicone mounting
support