Climadiff PCLP160 Gebrauchsanweisung Seite 48

3. TECHNICAL DATA
Below is an example of the nameplate:
The nameplate attached to the inside or rear of the appliance (depending on the model) includes the
entire information specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that you
can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.
4. INSTALLATION INSTRUCTIONS
Before using this appliance
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Use two or more suitably qualified people to move and install the appliance. Failure to do so can
result in back or other injury.
• When disposing your appliance, please choose an authorized disposal site.
• Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
• Adequate ventilation is required, do not block the front air outlet.
• This unit is intended for free-standing installation only. It must never be built-under or built-in. For
proper operation of the appliance, it is imperative to allow good air circulation around the unit. We do
not accept any liability instance of non-compliance with the installation instructions.
48