cecotec CONGA QUICK&CLEAN TITANIUM Bedienungsanleitung Seite 41

Verfügbare Sprachen

vacuum cleaner. Fig. 13

If the room to be cleaned is near a balcony or stairs, a physical barrier must be placed in

order to prevent product damage and ensure safe operation. Fig. 14

Direct exposure to sunlight or great light contrasts may affect the correct operation of the

sensors. If this happens, the robot will stop operating, move it to a new location for it to

start operating again.

3. INSTALLATION

Place the charging base against the wall and leave a minimum free space of 2 metres to

the front and 1 metre to each side. Fig. 15

Connect the charging base to a power socket. Wind and store the remaining cable in the

lower part of the charging base to prevent accidents. Fig. 16

Install both side brushes in their corresponding slots, located on the robot lower part.

Press until they click to make sure they are properly fixed. Fig. 17

Press the power switch located on the lower part of the robot. Make sure the power

switch is in the on position (I). Fig. 18

Place the robot on the charging base and make sure the charging terminals on the robot

match those of the charging base. Once the robot is properly placed, it will beep once and

the light indicator will light up. If the light is oscillating orange, it means the battery is

not completely charged. To ensure the maximum cleaning time, wait until the light turns

into steady blue, as this will indicate the battery is fully charged and the robot is ready to

clean. Fig. 19

4. OPERATION

Starting the cleaning. Fig. 20

Hold down the Start/Pause button on the robot to turn it on.

Press the Start/Pause button on the robot vacuum cleaner or on the remote control to

start cleaning.

Note

If the robot runs out of battery while cleaning, it will automatically return to the charging

base. Once the battery is fully charged, the robot can start a new cleaning cycle.

If there is no good access to the charging base, the robot will not be able to return to it. If

this happens, place it manually on the charging base.

Pausing the cleaning. Fig. 20

Press the Start/Pause button on the robot vacuum cleaner or on the remote control to

ENGLISH