Makita DCS553 Betriebsanleitung Seite 7

a preliminary assessment
of exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on
ways in
tool is used.
WARNING:
Be
identify safety
protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all
the operating cycle
as the times when the tool is
switched off and when it is running idle in addition to
the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of
conformity is
Annex A
manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING:
Read all safety warnings,
instructions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below
in electric
and/or serious
Save all warnings and
instructions for future reference.
The term "power
the warnings
your mains-operated
power tool
operated (cordless) power tool.
All manuals and user guides at all-guides.com
the
which the
sure to
measures to
parts of
such
included as
to this instruction
may result
shock, fire
injury.
tool" in
refers to
(corded)
or battery-
Cordless Metal Cutter safety
warnings
Cutting procedures
1. DANGER: Keep hands away from cutting
area and the blade. Keep your second hand
on auxiliary handle, or motor housing. If both
hands are holding
they
by
2. Do not reach underneath the workpiece. The
guard
from
the
3. Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the
blade teeth should be visible below the
workpiece.
4. Never hold the workpiece in your hands or
across your leg while cutting. Secure the
workpiece to a stable platform. It is important
to support
to
exposure, blade binding, or loss of control.
5. Hold the power tool by insulated gripping
surfaces, when performing an operation
where the cutting tool may contact hidden
wiring. Contact with a "live" wire will also make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
6. When ripping, always use a rip fence or
straight edge guide.
the
the chance of blade binding.
7. Always use blades with correct size and
shape (diamond versus round) of arbour
holes. Blades that do not match the mounting
hardware of the saw will run off-centre, causing
loss of control.
8. Never use damaged or incorrect blade
washers or bolt. The blade washers and bolt
were specially
saw,
performance
of
Kickback causes and related warnings
—
kickback is a sudden reaction to a pinched,
jammed
blade,
uncontrolled saw to lift up and out of the
workpiece toward the operator;
—
when the
or
the
7 ENGLISH
the saw,
cannot be cut
the blade.
cannot protect you
the blade below
workpiece.
the work properly
minimise body
This improves
accuracy of cut and reduces
designed for your
for optimum
and safety
operation.
or misaligned saw
causing an
blade is pinched
jammed tightly by
kerf closing down, the blade