Makita DCS553 Betriebsanleitung Seite 14

blade 4. Inner
washer
To install the circular saw blade, follow the removal
procedure in reverse.
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
WARNING:
If the inner flange is removed,
be sure to install it on the spindle. When
installing, choose a correct side on which
protrusion fits into the circular saw blade hole
perfectly. Mounting the circular saw blade on the
wrong side can result in the dangerous vibration.
Blade guard cleaning
When changing the circular saw blade, make sure to
also clean the upper and lower guards of accumulated
metal chips as discussed in the Maintenance section.
Such efforts do not replace the need to check lower
guard operation before each use.
OPERATION
CAUTION:
Always wear eye protection or
goggle before operation.
CAUTION:
Be sure to move the tool forward
in a straight line gently. Forcing or twisting the tool
will result in overheating the motor and dangerous
kickback, possibly causing
CAUTION:
Never twist or force the tool in the
cut. This may
overload and/or
dangerous kickback, resulting
serious injury
operator.
CAUTION:
Always use the circular saw blades
appropriate for your job. The use of inappropriate
circular saw blades
a poor
performance
a risk
injury.
CAUTION:
Do not use a deformed or cracked
circular saw blade. Replace it with a new one.
►
Fig.17
Hold the tool
tool is
both a
rear handle. Use both to best grasp the tool. If both
hands are
tool, they
cut by
All manuals and user guides at all-guides.com
flange 5. Cup
severe injury.
cause motor
a
in
to the
may cause
cutting
and/or present
of personal
firmly. The
provided with
front grip and
holding the
cannot be
the circular saw
blade. Set the base on the workpiece to
cut
saw
contact. Then turn the tool on and wait until
the circular saw
speed.
the
the
it
advancing smoothly
cutting
get
your
and
advance
cut
follow
line,
to turn or force the tool back to the cut line.
Doing so may
saw
to
possible
switch,
stop and then withdraw tool. Realign tool on new cut
line, and start cut again. Attempt to avoid positioning
which exposes operator to chips and
being
tool.
protection to
injury.
The sight
base
to
between the front edge of the circular saw blade and
the workpiece whenever the circular saw blade is set
to the maximum depth of cut. ► Fig.18:
Cutting line 2. Base 3. Sight grooves
CAUTION:
Do not stack materials when cutting
them.
CAUTION:
Do not cut hardened steel, wood,
plastics, concrete, tile, etc. Cut only mild steel,
aluminum and stainless steel with a suitable
circular saw blade.
CAUTION:
Do not touch the circular saw
blade, workpiece or cutting chips with bare hands
immediately after cutting.
be
could
CAUTION:
If the tool is operated continuously
until the battery cartridge has discharged, allow
the tool to rest for 15 minutes before proceeding
with a fresh battery.
14 ENGLISH
be
without the circular
blade making any
blade attains full
Now simply move
tool forward over
workpiece surface, keeping
flat and
until the
is completed. To
clean cuts, keep
cutting line straight
your speed of
uniform. If the
fails to properly
your intended cut
do not attempt
bind the circular
blade and lead
dangerous kickback and
serious injury. Release
wait for the circular saw blade to
particles
ejected from the
Use eye
help avoid
grooves in the
makes it easy
check the distance
1.
They may
extremely hot and
burn your skin.