Makita DCS553 Betriebsanleitung Seite 10

CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered,
in the
bursting causing
personal injury
damage. It
void the
warranty for
tool and
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before
completely discharged. Always stop tool
operation and charge the battery cartridge
when you notice less tool power.
2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F).
Let a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge. Failure
the tool
battery cartridge
cause them
off your
result in
the tool
cartridge and
personal injury.
►
Fig.1: 1. Red indicator 2. Button 3.
Battery cartridge
All manuals and user guides at all-guides.com
may result
battery
fires,
and
will also
Makita
the Makita
charger.
to hold
and the
firmly may
to slip
hands and
damage to
and battery
a
To remove
slide
tool
front of the cartridge.
To install
align
the
the
housing
into
all
it
with
If
the
the
the
not
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may
out
causing
or
CAUTION:
Do not install the battery cartridge
forcibly. If
not
it
inserted
Tool / battery protection system
The tool
a
This
cuts
the
tool
The
automatically
operation if
or
under one of the following conditions.
Overload protection
When the
in
causes
an
the
stops.
turn
and stop the application that caused the
tool to become overloaded. Then turn the tool on to
restart.
10 ENGLISH
the battery cartridge,
it from the
while sliding the button on the
the battery cartridge,
the tongue on
battery cartridge with
groove in the
and slip it
place. Insert it
the way until
locks in place
a little click.
you can see
red indicator on
upper side of
button, it is
locked completely.
accidentally fall
of the tool,
injury to you
someone around you.
the cartridge does
slide in easily,
is not being
correctly.
is equipped with
tool/battery protection system.
system automatically
off power to
motor to extend
and battery life.
tool will
stop during
the tool
battery is placed
tool/battery is operated
a manner that
it to draw
abnormally high current,
tool automatically
In this situation,
the tool off