Makita DCS553 Betriebsanleitung Seite 13

NOTE: Use a
to wipe
off the
the lamp. Be careful not to scratch the lens
of lamp, or it may
illumination.
Dust box
CAUTION:
Do not touch saw dust and the
dust box with bare hands immediately after the
operation. They may
extremely hot
burn your
CAUTION:
Do not cut the material on which
thinner, gasoline, grease, or other chemicals are
applied. The saw dust of such materials can damage
the dust box and result in breakage which can cause
personal injury.
CAUTION:
Wear eye protection or goggle
when emptying the dust box.
Saw dust is
the dust
Periodically
in the dust box before it gets full. Push the lever on the
dust box to open the lid. Dump the saw dust while the
rear of the tool faces downward. ►
1. Lid 2. Lever
►
Fig.10
Hook
Optional accessory
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high
locations or on the surfaces where the tool may
lose the balance and fall.
CAUTION:
Do not pull the tool downward
when it is hooked.
CAUTION:
Always fold the hook when
operating the tool.
The hook is
hanging the
temporarily. ►
Attach the hook with the screws as illustrated.
►
Fig.12: 1. Hook 2. Screw
To use the
turn the
it snaps
position.
All manuals and user guides at all-guides.com
dry cloth
the dirt
lens of
lower the
be
and could
skin.
collected into
box.
dump the saw dust
Fig.9:
convenient for
tool
Fig.11
hook, simply
hook until
into the open
When not
turn
it
closed position.
►
Fig.13:
position
Electric brake
This tool is equipped with an electric blade brake. If the
tool consistently
quickly
saw
have tool serviced at a Makita service center.
CAUTION:
The blade brake system is not a
substitute for blade guard. NEVER USE TOOL
WITHOUT A FUNCTIONING BLADE GUARD.
SERIOUS PERSONAL INJURY CAN RESULT.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in
the figure to
being
wrench
Installing or removing the circular
saw blade
CAUTION:
Use only the Makita wrench to
install or remove the circular saw blade.
CAUTION:
When installing the circular saw
blade, be sure to tighten the bolt securely.
CAUTION:
Be sure the circular saw blade is
installed with teeth pointing up at the front of the
tool.
►
Fig.15:
Tighten
4. Loosen
To remove the circular saw blade, press the shaft lock
fully so
saw
and
the hex bolt. Then remove the
outer
saw
►
Fig.16:
13 ENGLISH
in use, always
the hook until
snaps into the
1. Open position 2. Closed
fails to
stop the circular
blade after switch lever release,
keep it from
lost. ►
Fig.14: 1. Hex
1. Shaft lock 2. Hex wrench 3.
that the circular
blade cannot revolve
use the hex wrench to loosen
hex bolt,
flange and circular
blade.
1. Hex bolt 2. Outer
flange 3. Circular saw