Makita DCS553 Betriebsanleitung Seite 11

Overheat protection
When the tool/battery is
overheated,
stops automatically,
the battery
about 60
situation, let the tool cool down before turning the tool
on again.
On
Overdischarge protection
When the battery
low, the
automatically.
product does
even when the switches are
operated, remove the batteries from the tool and
charge the batteries.
Releasing protection lock
When the protection system
repeatedly, the
locked and
indicator shows
state.
Blinking
In this situation, the tool does not start even if turning
the tool off and on. To release the protection lock,
remove the battery,
to the
and wait
charging finishes.
Indicating the remaining battery
capacity
When you pull
trigger, the
indicator shows
remaining battery
Fig.2: 1. Battery
The remaining battery
shown as
table.
All manuals and user guides at all-guides.com
the tool
and
indicator blink
seconds. In this
Blinking
capacity becomes
tool stops
If the
not operate
works
tool is
the battery
the following
Off
set it
battery charger
until the
the switch
battery
the
capacity. ►
indicator
capacity is
the following
Battery indicator status
On
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.3:
button
Press the
the
indicate
capacity.
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature,
indication may
from
11 ENGLISH
Remaining
Off
Blinking
50
20 % to 50%
1. Indicator lamps 2. Check
check button
battery cartridge
the remaining battery
The indicator
Remaining
Off Blinking
75
50
25 % to 50%
The
malfunctioned.
the
differ
the actual
battery
capacity
% to 100%
0 % to 20%
Charge the
battery
on
to
lamps
capacity
% to 100%
% to 75%
0 % to 25%
Charge the
battery.
may
ba
slightly
capacity.