Herunterladen Diese Seite drucken

eta Fenite Bedienungsanleitung Seite 23

Ultraschall-gesichtsbürste
Vorschau ausblenden Andere Handbücher für Fenite:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 40
1) Make sure the appliance is switched off.
2) Connect the charging base C1 USB cable B into the charge slot
compatible AC wall adapter or mobile power) first and place the brush
body A into the charging base C. The charging procedure is signalled
by a flashing A5 LED indicator. When the battery is fully charged,
the A5 LED indicator light will go off. Unplug the adaptor from the
wall socket first and only then unplug the connector USB. For a full
charge, the battery needs to be charged for approximately 12 hours.
Depending on the cleaning mode used, a fully charged battery will
provide approximately 2-2.5 hours of operation which corresponds
to about 1-2 months when used twice a day for two minutes. While
charging, the appliance cannot be in use. If the appliance is turned on
and you start charging, the appliance shall switch off.
3) Do not exceed the designated charging time!
– When the battery of the accumulator is low and it needs to be
recharged, the LED indicator A5 starts flashing.
– When charged for the first time, or if the appliance was not in use for
more than 3 months, it needs to be charged for 12 hours.
– The charging base also serves as a stand where you can place the
brush after use. However, do not connect the base to the mains
unless you wish to charge the brush. Do not leave the charging base
connected to the mains permanently!
– The operating time is only approximate. The time depends on
the condition of the battery, ambient temperature, age, method of
charging, etc.
– Do not use USB ports on other devices (e.g. computer, laptop, tablet,
mobile phone, etc.) to power the appliance. These devices do not have
to be designed for current consumption of the appliance and could be
damaged.
Use (fig. 3)
Put your favouring cleaning gel on your face or use water. Dip the
cleaning parts of the brush (bristles or massage waves) in water. Then
clean the individual parts of your face by circular motions. Do not press
down the brush too much. Once you finish the cleaning, rinse your skin
with clear water, or treat your skin with a suitable skin lotion. Use daily
for better results.
In operation vibration
In operation vibration
and heating
Discharged status
Charging
After full charge
Caution
Functions of control light
Appliance stops and indicator light turns off.
When you try to switch the appliance on,
it shall remain off and indicator light flash
„green" 6 times
23
/ 47
Fast blue
Fast red
Fast green
Off
EN

Werbung

loading

Diese Anleitung auch für:

8353