Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
The device has two different DMX channel modes.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-75 will respond to the controller.
If you set, for example, the address in the 13 channel mode to channel 14, the device will use the channel 14
to 26 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-75 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-75 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-75 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
DMX-protocol
The device has two different DMX channel modes. The Control Board allows you to assign the DMX channel
mode.
Mode/Channel
Decimal
Stan-
Basic
dard
1
1
0
2
2
0
3
3
0
Hexad.
Percentage
255
00
FF
0%
255
00
FF
0%
223
00
DF
0%
S/F
Horizontal movement (PAN)
Push slider up in order to move the head
horizontally (PAN). Gradual head adjustment
100%
F
from one end of the slider to the other (0-255,
128-center). The head can be stopped at any
position you wish.
Vertical movement (TILT)
Push slider up in order to move the head
vertically (TILT). Gradual head adjustment from
100%
F
one end of the slider to the other (0-255, 128-
center). The head can be stopped at any position
you wish.
PAN/TILT speed
87%
F
Decreasing speed
31/35
Feature
00085389.DOC, Version 1.0
Werbung
