Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connect
DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
Slave setting
With this function, you can define the device as slave.
Program Run, Master setting
With this function, you can run the internal program.
The selection "Alone" means stand-alone mode and "Master" that the device is defined as master.
Music, Master setting
With this function, you can run the internal program sound-controlled.
The selection "Alone" means stand-alone mode and "Master" that the device is defined as master.
Light
Max Temperature
With this function you can set the inside temperature at which the projector will automatically switch the lamp
off. Press Up or Down to select the maximum inside temperature between 80 °C and 139 °C. Inside
temperatures below 90 °C are not critical. 90 °C and more should lead to the lamp being switched off. Please
note that the outside temperature should not exceed 45 °C.
Information
Lamp Temp / Temperature near LED
With this function you can display the temperature in the projector-head (near LED) in degree Celsius.
Set
Reset
With this function you can Reset the device via the Control Board.
Movement
PAN Reverse
With this function you can reverse the PAN-movement.
TILT Reverse
With this function you can reverse the TILT-movement.
Automatic PAN/TILT correction (Feedback)
With this function you can adjust the PAN/TILT movement to the correct starting position.
Adjust PAN/TILT speed
With this function you can define the PAN/TILT speed. You can select one of two different modes.
UI Set
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
29/35
00085389.DOC, Version 1.0
Werbung
