EuroLite LED TMH-75 Bedienungsanleitung Seite 27

OPERATION
After you connected the effect to the mains, the EUROLITE LED TMH-75 starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.
Stand-alone operation
In the Stand-alone mode, the LED TMH-75 can be used without controller.
Disconnect the LED TMH-75 from the controller and call the internal program. Please refer to the instructions
under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode for the master-device. Set the Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.
27/35 00085389.DOC, Version 1.0