Makita DF333D Betriebsanleitung Seite 9

CAUTION:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the
pull the switch
speed is increased by
increasing pressure on
trigger. Release the switch trigger to stop.
Lighting up the front lamp
►
Fig.4: 1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch
light up the
lamp keeps on
the switch trigger
pulled. The lamp
approximately 10
releasing the switch
NOTE: Use a
to wipe
off the
the lamp. Be careful not to scratch the
lens of lamp, or it may
illumination.
Reversing switch action
►
Fig.5: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only
after the tool comes to a complete stop. Changing
the direction
the
damage
CAUTION:
When not operating the tool,
always set the reversing switch lever to the
neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for
or from the
for counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch
be pulled.
Speed change
►
Fig.6: 1. Speed change lever
Position of Speed
speed
change
lever
tool, simply
trigger. Tool
the switch
trigger to
lamp. The
lighting while
is being
goes out
seconds after
trigger.
dry cloth
the dirt
lens of
lower the
of rotation before
tool stops may
the tool.
clockwise rotation
B side
trigger cannot
Torque Applicable
operation
1
2
9 ENGLISH
Low High
High Low
Heavy
l
oading
operation
Light loading
operation