Makita DF333D Betriebsanleitung Seite 8

cartridge
personal
►
Fig.1: 1. Red indicator 2. Button 3.
Battery cartridge
To remove the
cartridge, slide it
tool while sliding
on the front
cartridge.
To install the
cartridge, align the
the battery cartridge
groove in the
slip it into
it all the
it locks in
a little click.
can see the
on the upper
the button, it
locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may
out
causing
or
CAUTION:
Do not install the battery cartridge
forcibly. If
not
it
inserted
Battery protection system
The tool is
a battery protection system.
system automatically
power to the
extend battery life.
The tool will
stop during operation if
tool and/or battery
under one of
following conditions:
Overloaded:
The tool is operated in a manner that causes it to draw
an abnormally high
In this situation, turn the tool off and stop the
application that caused
to become overloaded.
turn the tool on to restart.
If the tool
start, the battery
and a
injury.
battery
from the
the button
of the
battery
tongue on
with the
housing and
place. Insert
way until
place with
If you
red indicator
side of
is not
accidentally fall
of the tool,
injury to you
someone around you.
the cartridge does
slide in easily,
is not being
correctly.
equipped with
This
cuts off
motor to
automatically
the
are placed
the
current.
the tool
Then
does not
is
overheated.
situation, let
before turning
again.
Low battery voltage:
The remaining battery
too low
will not
turn the
motor runs
soon. In
and recharge
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.2:
Check button
Press the
the battery
the remaining battery
indicator lamps
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature,
indication may
from
capacity.
Switch action
►
Fig.3:
8 ENGLISH
In this
the battery
the tool
capacity
and the
operate. If
tool on,
again but
this situation,
the battery.
1. Indicator lamps 2.
check button
cartridge to
capacity.
light up for a few seconds.
Remaining
capacity
Of
f
75% to 100%
50% to 75%
25% to 50%
0% to 25%
the
differ
the actual
1. Switch trigger
cool
on
is
tool
you
the
stops
remove
on
indicate
The
slightly