Makita DF333D Betriebsanleitung Seite 6

Vibration
The vibration total
vector sum) determined according to
EN62841-2-1:
Model DF333D
Work mode: drilling
Vibration emission (a
2
m/s or less
Uncertainty (K) :
Model DF033D
Work mode: drilling
Vibration emission (a
2
m/s or less
Uncertainty (K) :
NOTE: The
emission
measured in
with
method
used
tool
NOTE: The
emission
be
preliminary assessment
exposure.
WARNING:
emission
the power tool can differ from the declared emission
value
ways
tool is used.
WARNING:
identify
protect
are
estimation of exposure in the actual
conditions of use (taking account of
parts
operating cycle
the times when the tool is switched off
and when it is running idle in addition to the trigger
time).
EC Declaration of Conformity
For European countries only
The EC declaration of
conformity is included
A to this instruction manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING:
Read all safety warnings,
instructions, illustrations and specifications
provided with this power tool.
follow
below
value (tri-axial
into metal
) : 2.5
h,D
1.5 m/s
into metal
) : 2.5
h,D
1.5 m/s
declared vibration
value has been
accordance
the standard test
and may be
for comparing one
with another.
declared vibration
value may also
used in a
of
The vibration
during actual use of
depending on the
in which the
Be sure to
safety measures to
the operator that
based on an
all
of the
such as
as Annex
Failure to
all instructions listed
may result in
Save all warnings and
instructions for future reference.
The term
2
the warnings
mains-operated
or battery-operated
tool.
2 Cordless driver drill safety
warnings
1. Use auxiliary handle(s), if supplied with the
tool. Loss
cause
2. Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring.
contacting a
may
parts
tool "live" and could give the operator an
electric shock.
3. Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden wiring.
Fasteners
wire
metal parts of the power tool "live" and could give
the operator an electric shock.
4. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
5. Hold the tool firmly.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the
tool only when hand-held.
8. Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
9. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
10. If the drill bit cannot be loosened even you
open the jaws, use pliers to pull it out. In such
a case,
drill
may
by
SAVE THESE INSTRUCTIONS.
6 ENGLISH
electric shock, fire
serious injury.
"power tool"
refers to
(corded) power
(cordless) power
of control
personal injury.
Cutting accessory
"live"
make exposed
of the
contacting a
may make
pulling out
bit by
result in
its sharp
and/or
in
your
tool
can
wire
metal
power
"live"
exposed
the
hand
injury
edge.