Makita DF333D Betriebsanleitung Seite 10

To change the
off the tool
CAUTION:
Always set the speed change lever
fully to the correct position.
operate
the
positioned halfway
"1"
side,
be
CAUTION:
Do not use the speed change lever
while the tool is running.
may
The fastening torque
turning the
the arrow
the minimum
at
levels when
The clutch
Before actual operation, drive
or a
torque level is required for a particular application.
The following shows
the screw
Graduation
Machine screw
Wood Soft wood
screw (e.g. pine)
Hard wood
(e.g. lauan)
the "2" side
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
drill bit
For Model DF333D (optional accessory)
►
Fig.8: 1. Sleeve 2. Close 3. Open
Turn the sleeve counterclockwise to open the chuck
jaws. Place the
bit in the
far as it will go. Turn the sleeve clockwise to
tighten the chuck. To
driver bit/drill bit,
sleeve counterclockwise.
speed, switch
first. Select
If you
the tool with
speed change lever
between the
side and "2"
the tool may
damaged.
The tool
be damaged.
can be
adjusting ring.
on the
fastening torque
marking. The clutch
set at
does not
a
piece of
the rough
size and
1 2 3 4 5
M4
–
for high
driver bit/drill
chuck as
remove the
turn the
speed
speed
torque. Be sure that the speed change lever is set to the
correct position
If the tool
down extremely during
with "2", slide the lever to the "1" and restart the operation.
Adjusting the fastening torque
►
Fig.7:
Graduation 3.
adjusted in
Align the
tool body.
at 1
will slip
the number
work at
trial screw
duplicate material
guide of
graduation.
6 7 8 9 10 11
–
–
Installing or removing driver bit/
socket bit
For Model DF033D (optional accessory)
►
Use
that
in
use
bit/socket bit.
NOTE: Both
To
pull
direction
insert
10 ENGLISH
or "1"
but high
before operation.
speed is
the
1. Adjusting ring
Arrow
21 levels
graduations
You can
and maximum torque
at various
1 to
the marking.
into your
to determine which
the relationship between
12 13 14 15 16
M5
ɸ3.5 x 22
ɸ3.5 x 22
Fig.9
only driver bit/socket bit
has inserting portion
the figure. Do
any other driver
shallower type
mm, B=9 mm)
deeper type (A=17
B=14 mm) of
bits can be
install the driver
the sleeve in
of the arrow
the driver bit
for low
coming
operation
2.
by
with
get
torque
20.
material
17 18 19 20
M6
ɸ4.1 x 38
–
ɸ4.1 x 38
shown
not
(A=12
and
mm,
driver
used.
bit,
the
and
into