Makita DF333D Betriebsanleitung Seite 11

Installing hook
the sleeve as
it will go.
Then release the
secure the driver
Fig.10: 1. Driver
Sleeve
To remove the
pull the sleeve
direction of the
pull the driver
NOTE: If the
is not
enough into the sleeve, the sleeve will
not return to its original position
driver bit
be secured.
case, try
bit according to
instructions above.
NOTE: After inserting
bit, make
it is
secured. If
out, do
it.
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook
may come
tool
the
►
Fig.11: 1. Groove 2. Hook 3. Screw
The hook is
temporarily hanging the
can be installed
side of the
install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing driver bit holder
Optional accessory ►
Fig.12: 1. Driver
holder 2. Driver
Fit the driver
into the protrusion at
tool foot on either right or left side and
secure it with a screw. When
the driver bit,
in the driver
Driver bits 45
be kept there.
far as
sleeve to
bit. ►
bit 2.
driver bit,
in the
arrow and
bit out.
driver bit
inserted deep
and the
will not
In this
re-inserting the
the
the driver
sure that
firmly
it comes
not use
off from the
and result in
personal injury.
convenient for
tool. This
on either
tool. To
bit
bit
bit holder
the
not using
keep it
bit holders.
mm-long can
Drilling operation
OPERATION
CAUTION:
Always insert the battery cartridge
all the way until it locks in place.
you
red
upper
button,
locked
fully
indicator
If
accidentally
of
causing
or
CAUTION:
When the speed comes down
extremely, reduce the load or stop the tool to
avoid the tool damage.
Hold the
one hand
and the
the bottom
battery cartridge
twisting action. ►
Screwdriving operation
CAUTION:
Adjust the adjusting ring to the
proper torque level for your work.
CAUTION:
Make sure that the driver bit is
inserted straight in the screw head, or the screw
and/or driver bit may be damaged.
Place the
driver bit
head and
the tool.
slowly and
speed gradually. Release
trigger as soon as the clutch cuts in.
NOTE: When driving wood screw, pre-drill a pilot
hole 2/3 the
screw.
easier
workpiece.
First, turn
so that
to the marking. Then proceed as follows.
Drilling in wood
When drilling
best results
wood drills equipped with a guide screw. The guide
screw makes
pulling the
the workpiece.
11 ENGLISH
can see
indicator on
side of
it is
completely. Insert
until the
cannot be
not, it
fall
the tool,
injury to
someone around
tool firmly with
on the grip
other hand on
of the
to control the
Fig.13
point of the
in the screw
apply pressure to
Start the tool
then increase the
the switch
diameter of the
It makes driving
and prevents splitting of the
the adjusting ring
the arrow points
in wood, the
are obtained with
drilling easier by
drill bit into
If
the
the
the
not
it
red
seen.
may
out
you
you.