Connection With The Mains; Operation; Manual Control; Remote Control - EuroLite 500 IR Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
Attention! The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the effect to the mains, the LEDs of the LED Techno Strobe 500 IR light up briefly.
The device has two operating modes. It can be operated manually via the rotary dial on the device rear or via
the IR remote control included in delivery.

Manual Control

Press and hold the rotary control for 1-3 seconds and the device starts running. After switching on, the LEDs
light up according to the last control program selected. To change modes, press, then release, the rotary
control dial. To switch the device off, press and hold the rotary control for 1-3 seconds again.
Mode
Static LEDs static on; brightness adjustable via rotary control. 22 levels are available.
Flash Strobe effect; speed adjustable via rotary control. 20 levels are available.
Sound Sound control; sensitivity adjustable via rotary control. 32 levels are available.
Brightness, speed and sensitivity increase when the rotary control is turned clockwise and decrease when
the rotary control is turned counter-clockwise.

Remote Control

The remote control is supplied with a battery inserted. An insulating foil between the battery and the
1
battery contacts prevents the battery from being discharged during storage. Prior to the first operation
remove the foil from the battery support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
When actuating a button, always hold the remote control in the direction of the sensor (centrally located
2
on the device front). There must be visual connection between the remote control and the sensor.
If several systems are to be controlled by a single remote control, position the control units with their
3
sensors close to each other.
If the range of the remote control decreases (8 meters as a maximum), replace the battery. For this
4
purpose, on the rear side of the remote control press the small bar with the groove
to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the
5
positive pole of the button cell shows upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type. Please
dispose of old and used batteries properly. Batteries are hazardous waste and should not be
disposed of with regular domestic waste!
International
L
N
Control programs with variable settings
CAUTION!
14/16 00082042.DOC, Version 1.0