PCE Instruments PCE-VT 3900 Bedienungsanleitung Seite 55

7 Data logger
With the help of the data logger function, measured values can be logged over a defined period
of time. A total of 50 memory locations is available for the saved data records. The PC software
must be used to display the data records.
7.1 Settings
The same settings are used for the measurement parameters as for the regular measurement
mode. These can be set in the Measurement menu. The settings specific to data logger mode
are in the Data logger menu.
Fig. 31 Data logger
The storage interval can be set between 1 s ... 12 h. This means that only the measured values
within the set interval are saved. The measured value display during logging updates at the same
rate as in regular measuring mode.
The data logger can be started in two different ways: either manually via the OK key or a start
time can be set via the Start condition menu.
There are three different options for stopping the data logger. These can be selected via the Stop
condition menu. It can be stopped manually by pressing the OK key, at a specific time or after
a configurable time interval.
The start and stop conditions can be combined in any way.
When selecting date/time as the start or stop condition, the start of the data logger is prevented
if the set start/stop time is before the current time or if the stop time is before the start time. In this
case, the corresponding settings must be checked and corrected.
After the desired data logger settings have been selected, the data logger can be started.
© PCE Instruments
50