Werbung
Verfügbare Sprachen
Verfügbare Sprachen
28
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap‐
pliance is too low/too high.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easily.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The FastFreeze function is
switched on.
The temperature regulator is
not set correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
You attempted to re-open
the door immediately after
closing.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze man‐
ually, or wait until the func‐
tion resets automatically to
set the temperature. Refer
to "FastFreeze function"
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion".
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of
the door.
Werbung
