LOAD
Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set
back to the default values (shaded).
• Select "LOAD" by pressing [UP] or [DN].
• Press [ENTER], the display shows "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you
don't.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
VER
Software version
With this function you can display the software version of the device.
• Select "VER" by pressing [UP] or [DN].
• Press [ENTER], the display shows "X.X.XX", "X.X.XX" stands for the version number, e.g.
"1.0.0", "2.6.0".
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
UI
Hibernation - power standby mode
With this function you can put the device in the power standby mode. This function will be
automatically activated after a predefined period of time of no DMX activity. In standby mode
the lamp/LEDs and all motors will power down if no DMX signal is sent to the fixture for a
period of e. g. 15 minutes (can be user defined). The fixture will automatically reset and
return to normal operation once a DMX signal is sent.
• Select "HIBE" by pressing [UP] or [DN].
• Press [ENTER] to confirm, the display shows "XXM" or "ON". "X" stands for the minutes.
• Press [UP] or [DN] to select "1-99M" for the desired time – or "ON" to deactivate this
function.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
Backlight
With this function you can shut off the display after 1 to 99 minutes.
• Select "BACK" by pressing [UP] or [DN].
• Press [ENTER] to confirm, the display shows "XXM"or "ON". "X" stands for the minutes.
• Press [UP] or [DN] to select "1-99M" for the desired time – or "ON" to deactivate this
function.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
Reverse display
With this function you can rotate the display by 180°.
• Select "FLIP" by pressing [UP] or [DN].
• Press [ENTER], the display shows "OFF".
• Press [UP] to select "ON" if you wish to enable this function (the display will rotate by
180°) or [DN] to select "OFF" if you don't.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
MIC
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 80 % and 88
%.
• Select "MIC" by pressing [UP] or [DN].
• Press [ENTER] to confirm.
• Press [UP] to select the desired sensitivity.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
26/30
00094808.DOC, Version 1.0