Herunterladen Diese Seite drucken

EuroLite WF-40 Bedienungsanleitung Seite 23

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Stand-alone operation
In the Stand-alone mode, the device can be used without controller. You can do without a controller as the
device features internal programs. For Stand-alone operation, disconnect the device from the controller.
Please refer to the instructions under Control Board.
Master/Slave-Operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the EUROLITE LED WF-40 you can find an XLR-jack and an XLR-plug, which can be
used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the master device to the stand-alone operation mode. For this adjust the sub menu SUND, SEQ1 or
SEQ2 under the main menu MODE. Set each slave device to the same DMX address "001".
Please refer to the instructions under Control Board.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the device to the mains, the device starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in Stand-alone or in DMX-controlled mode via
lighting controller.
International
L
N
23/30
00094808.DOC, Version 1.0

Werbung

loading