Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INFO
• Press [MODE] to enter the main menu "INFO"
• Press [ENTER] and select "DRIT" by pressing [UP] or [DN].
Temperature near LED driver
With this function you can display the temperature in the device (near LED driver) in degree Celsius.
• Select "DRIT" by pressing [UP] or [DN].
• Press [ENTER], the display shows"XXXC", "X" stands for the temperature.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
LAMP
• Press [MODE] to enter the main menu "LAMP"
• Press [ENTER] and select "TEMP" or "ADJU" by pressing [UP] or [DN].
• Press [ENTER] for selecting the desired sub menu.
Max. Temperature
With this function you can set the inside temperature at which the projector will automatically switch
the lamp/LEDs off. Inside temperatures below 90 °C are not critical. 90 °C and more should lead to
the lamp/LEDs being switched off. Please note that the outside temperature should not exceed 45
°C.
• Select "TEMP", to select the maximum inside temperature between 80 °C and 130 °C, by pressing
[UP] or [DN].
• Press [ENTER] to confirm, the display shows "90°C ".
• Press [UP] or [DN] to select "80-130°C" for the desired inside temperature.
• Press [ENTER] to confirm.
• Press [MODE] in order to return to the main menu.
DMX-controlled operation
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing
Each EUROLITE LED WF-40 occupies 9 DMX-channels. The Control Board allows you to select the DMX
starting address, which is defined as the first channel from which EUROLITE LED WF-40 will respond to the
controller.
If you set, for example, the address to channel 10, the LED WF-40 will use the channel 10 to 18 for control.
Please make sure that you don't have any overlapping channels in order to control each EUROLITE LED
WF-40 correctly and independently from any other fixture on the DMX data link.
If several EUROLITE LED WF-40 are addressed similarly, they will work synchronically.
Note:
The modes of DMX512 data are shown via the display of the device:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
27/30
00094808.DOC, Version 1.0
Werbung
