Makita AT450H Betriebsanleitung Seite 10

Maintenance of compressor, air set and
air hose (Fig. 25 & 26)
After operation, always drain the compressor tank and the
air filter. If moisture is allowed to enter the tool, It may
result in poor performance and possible tool failure.
Check regularly to see if there is sufficient pneumatic oil in
the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly. (Fig. 27)
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which it
may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges and
areas which may lead to damage or abrasion to the hose.
(Fig. 28)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Staples
• Air hoses
• Safety goggles
10
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 80 dB (A)
sound power level: 93 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration value
is not more than 2.5 m/s
Uncertainty (K): 1.5 m/s
These values have been obtained according to EN792.
EC-DECLARATION OF CONFORMITY
Model; AT450H
We declare under our sole responsibility that this product
is in compliance with the following standards of
standardized documents;
EN792 in accordance with Council Directives, 98/37/EC.
Tomoyasu Kato
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
2
.
2
.
CE 2008
Director
ENG045-2
ENH013-7