Maintenance - Makita AN901 Betriebsanleitung

Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
Humid
005382

MAINTENANCE

CAUTION:
Always disconnect the hose before attempting to
•
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
Fig.17
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do not
use tool if the contact element or trigger sticks or binds.
Fig.18
Make sure that the trigger is locked when the change
lever is set to the LOCK position.
Fig.19
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place. Avoid exposure to direct sunlight
and/or humid or hot environment.
Fig.20
Fig.21
Maintenance of compressor, air set and air
hose
Fig.22
Fig.23
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool, It may
result in poor performance and possible tool failure.
Check regularly to see if there is sufficient pneumatic oil
in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
Fig.24
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which it
may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges and
Hot
areas which may lead to damage or abrasion to the hose.
Thinner
005390
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance and adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
9
Stove