Starting The Set-Up Wizard; Viewing Software Information; Data Protection; Setting The Backlight - Medion P85333 Bedienungsanleitung

25.8. Starting the set-up wizard

Select SETUP WIZARD to start the setup wizard as described in section "Using the
device for the first time".

25.9. Viewing software information

The software version and radio identification number of the device are shown
under INFO.
25.10.

Data protection

The privacy policy is displayed under PRIVACY POLICY. This can be viewed at
www.frontiersmart.com/privacy.
25.11.

Setting the backlight

You can configure the backlight under BACKLIGHT:
– Dim the display in standby or operating mode after a pre-determined time
– Display brightness
Setting the dim time during operation
 Select POWERON TIMEOUT: and press OK to confirm. Select ON, 10, 20,
30, 45, 60, 90, 120 or 180 seconds and press OK to confirm.
Display brightness during operation
 Select POWERON LEVEL and press OK to confirm. Set your preferred
brightness, HIGH, MEDIUM, LOW, and press OK to confirm.
The brightness of the control dials cannot be changed.
Setting the dim time in standby mode
 Select STANDBY TIMEOUT: and press OK to confirm. Select 10, 20, 30, 45,
60, 90, 120 or 180 seconds and press OK to confirm.

Setting the display brightness in standby mode

 Select STANDBY LEVEL and press OK to confirm. Set your preferred brightness,
MEDIUM, LOW, and press OK to confirm.
372