Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
Mounting
2.1
General information on installation/dismounting
WARNING!
The device is not designed for use in potentially explosive areas.
Explosion hazard.
Only deploy the device outside of potentially explosive areas.
Mounting site
The device is designed for installation in a panel cut-out. The front of the device and housing have dif-
ferent protection types (see technical data).
Climatic conditions
The ambient temperature and the relative humidity at the mounting site must correspond to the technical
data. Aggressive gases and vapors have a negative effect on the operating life of the device. The mount-
ing site must be free from dust, powder, and other suspended solids.
Mounting the input/output modules
When mounting the modules on the rear of the device (DIN rail available as an accessory), the installa-
tion instructions or operating manuals of the modules must be observed in addition to this document.
chapter 1.6 "Available technical documentation", Page 13
Only modules of type 7050xx (router module, multichannel controller module, input and output modules)
are allowed to be mounted on the rear side of the device.
2.2
Dimensions
Panel cut-outs
See technical data
Close mounting
Distance between panel cut-outs
Minimum clearance
Recommended distance (easier mounting of mounting ele-
ments)
The distances to other devices must be selected in a way that the maximum admissible ambient tem-
perature of this device is not exceeded.
NOTE!
The device must be installed with the screen aligned horizontally!
2 Mounting
Horizontal
Vertical
30 mm
30 mm
50 mm
50 mm
17
Werbung
Inhaltsverzeichnis
